Showing 2 results for Noroozi
Mr. Vahid Manshaei, Dr. Mohammad Javad Noroozi, Mr. Ali Shaafi,
Volume 10, Issue 2 (6-2020)
Abstract
In this research, the separate and simultaneous effects of pilot-main injection dwell time, pilot fuel quantity, and hydrogen gas addition on combustion characteristics, emissions formation, and performance in a heavy-duty diesel engine were investigated. To conduct the numerical study, valid and reliable models such as KH-RT for the break-up, K-Zeta-F for turbulence, and also ECFM-3Z for combustion were used. The effects of thirty-one different strategies based on two variables such as pilot-main injection dwell time (20, 25, 30, 35, and 40 CA) and pilot fuel quantity (5, 10, and 15% of total fuel per cycle) on NDC and DHC were investigated. The obtained results showed that by decreasing pilot-main injection dwell time due to shorter combustion duration and higher MCP, MCT, and HRRPP, amounts of CO and soot emissions decreased at the expense of high NOx formation. Also, increasing pilot fuel quantity due to higher combustion temperature and less oxygen concentration for the main fuel injection event led to an increase of NOx and soot emissions simultaneously. The addition of H2 due to significant heating value has increased IP and improved ISFC at the expense of NOx emissions but considerably decreased CO and soot emissions simultaneously.
Dr. Mohammad Javad Noroozi, Mr. Mahdi Seddiq, Mr. Hessamedin Habibi,
Volume 10, Issue 4 (12-2020)
Abstract
Due to very low PM and NOx emissions and considerable engine efficiency, dual-fuel combustion mode such as RCCI strategy attracted lots of attention compared to other combustion modes. In this numerical research work, the impacts of direct injection timing and pressure of diesel fuel on performance and level of engine-out emissions in a diesel-butanol RCCI engine was investigated. To simulate the combustion process, a reduced chemical kinetic mechanism, which consists of 349 reactions 76 species was used. The influence of thirty-six various strategies based on two diesel spraying characteristics such as injection pressure (650, 800, 1000, and 1200 bar) and diesel spray timing (300 to 340 CA with 5 CA steps) have been examined. Results indicated that, under the specific operating conditions like 1000-bar spray pressure by direct injection at 45 CA BTDC and the spray angle of 145 degrees, the level of cylinder-out pollutants such as CO (up to 26%), NOx (about 86%), PM (by nearly 71%) and HC (about 17.25%) have been simultaneously reduced. Also, ISFC decreased by about 2.3%, IP increased by about 2.4%, and also ITE improved by nearly 2% compared to the baseline engine operating conditions.
